Description
This is our page for ordering our LED lights, wiring harnesses and turn signals on their own. A detailed description of each lighting option is given below.
We can also provide weld-on mounting tabs to mount these lights to your existing bumper or roof rack. These tabs are slotted for adjustability and available in either 3/16″ steel or 1/4″ aluminum. Please leave a note in the order comments section when placing your order and we will reach out to you to confirm.
40W CREE LED Lights:
•Surface Mount Light which gives tons of adjustability up and down and side to side so fine tune your light spread
•Available in Clear/white and Amber. (Clear/white is standard. For Amber lights, please leave a note in the order comments section. There is no extra charge)
•Operating Voltage: 10-30V DC
•Light output: 3800 lumen
•Color temperature: 6000K/3000K
•Operating temperature: -40°C~60°C
•Beam Pattern: Spot
•Material: Die cast aluminum housing with stainless steel bracket
•Lens: Polycarbonate
•Light Housing Dimensions: 3″ tall x 3″ wide x 2.75″ deep (76 x 76 x 70mm)
24W CREE LED Lights:
•Surface Mount Light which gives tons of adjustability up and down and side to side so fine tune your light spread
•Available in Clear/white
•Operating Voltage: 10-30V DC
•Light output: 2300 lumen
•Color Temperature: 6000K
•Operating temperature: -40°C~60°C
•Beam Pattern: Flood/ Spot combo (90/8 degree)
•Material: Die cast aluminum housing with stainless steel bracket
•Lens material: PMMA
•Light Housing Dimensions: 3″ tall x 3″ wide x 2.75″ deep (76 x 76 x 70mm)
•Current draw: 3.3 @12V, 1.65A@24V
With Harness:
•This option includes the lights, mounting bracket and all hardware, as well as a complete plug and play wiring harness to wire these into your vehicle on their own circuit. This includes the switch to mount in your interior, the relay, battery terminal connectors, wiring, and the industry standard waterproof DT plug waterproof connectors to easily disconnect each light (used by Rigid, Baja Designs, etc). All of the wiring and connectors are ready to go, so no soldering or splicing is required. The harness comes complete and ready to install. Please note that the wiring length is designed for front bumper installs, so rear bumper or roof rack light applications may require that you extend the wiring.
Without Harness:
•This option includes the lights, mounting bracket and all hardware, as well as the industry standard waterproof DT plug waterproof connectors to easily disconnect each light (used by Rigid, Baja Designs, etc). This includes the female end and male end with an extra length of blank wire, which is not pictured. This option is recommended for easily splicing into your existing factory fog light circuit so you can operate the lights from your factory fog light switch. This also avoids the need to run any wiring through your engine bay or firewall.
Turn Signals
•Includes two 2″ LED turn signals, rubber grommets, and the connectors and wiring to easily splice these into your existing turn signal wiring. These turn signals have a clear lens which illuminates in amber. These are designed to fit in a 2.25″ (50mm) diameter hole.
Reviews
There are no reviews yet.